Endurorider PLUS

With wider rim as our Endurorider

1805 gramm

Endurorider PLUS Wheels

The ENDURORIDER PLUS is s based on our many years of experience in wheel building and was developed together with the GHOST FACTORY RACING ENDURO team. The German women’s champion Franzi Meyer and the 4-cross world champion Michal Prokop are racing on these wheels. The final product is a “Made in Europe” wheelset, spokes and nipple come from SAPIM Belgium, rims from RYDE Netherlands and in the center we placed our King & Kong hubs. Of course available in all build-in widths, axle standards and Tune-colours… fitting nipple colours and rim decals are in stock!

A pro wheelset that convinces technically, practically and with a beautiful design!


Sapim D-Light

A double butted spoke is drawn to its specific profile, which defines its high strength. The short 2 mm section of the D-Light reduces weight especially on the threaded side. The 2mm section starts just at the beginning of the thread. Therefore, the rotating masses at the end of the spoke are especially reduced. This brings benefits to both the acceleration and braking qualities of the wheel. The use of 14G nipples offers a wide variety of combinations. The middle section is increased to 1,65 mm, which makes the spoke much stiffer and brings less torsion during truing than a 1,5 mm middle section. This results in an easier building process of the wheels.


We use standard bearings. This means you can also buy bearings in Australia if you need to. Ours are just a little special, with two main differences: Our bearings have a higher fat filling grade. 30% is standard, whilst ours are filled to 50%. This not only prolongs their life, but also provides a better seal. Standard bearings have variations in play from their production. Tune bearings have the play specially determined dependent on their use. One single Tune bearing is not standard – the bearing in the free-wheel body on the left. It is constructed specifically to withstand high forces and last extra long.


Specs Endurorider PLUS

Hubs King / Kong
Wheel Tune Endurorider PLUS
Number of holes 32/32
Nipple Sapim, aluminum, anodized
Spokes SAPIM D-Light, black-oxidized
Max. Driver weight 120 kg
Marathon 40
XC 40
AllMountain 80
Enduro 100
Downhill 40
Endurorider PLUS

Our Enduro Wheelset! Built with our in-house Tune Endurorider rim our classic King and Kong

Rims Endurorider PLUS

Height 21.6 mm
External width 45.1 mm
Internal width 40 mm
ERD 555 mm (650B)
Max. Tire pressure 45 psi / 3.0 bar
Tire widths 3.5"
Weight (± 5%) 560g
tune Wheels

The tuning of running wheels has the most noticeable effect when it comes to weight savings. All the wheels are hand-fed, pressed and perfectly centered. Our bikes stand for the highest quality and have proven themselves over millions of kilometers.