The ENDURORIDER is s based on our many years of experience in wheel building

29 Zoll: 1829 gramm 650B: 1751 gramm

Endurorider Wheels

The ENDURORIDER is s based on our many years of experience in wheel building and was developed together with the GHOST FACTORY RACING ENDURO team. The German women’s champion Franzi Meyer and the 4-cross world champion Michal Prokop are racing on these wheels. The final product is a „Made in Europe“ wheelset, spokes and nipple come from SAPIM Belgium, rims from RYDE Netherlands and in the center we placed our King & Kong hubs. Of course available in all build-in widths, axle standards and Tune-colours… fitting nipple colours and rim decals are in stock!

A pro wheelset that convinces technically, practically and with a beautiful design!

Sapim D-Light

A double butted spoke is drawn to its specific profile, which defines its high strength. The short 2 mm section of the D-Light reduces weight especially on the threaded side. The 2mm section starts just at the beginning of the thread. Therefore, the rotating masses at the end of the spoke are especially reduced. This brings benefits to both the acceleration and braking qualities of the wheel. The use of 14G nipples offers a wide variety of combinations. The middle section is increased to 1,65 mm, which makes the spoke much stiffer and brings less torsion during truing than a 1,5 mm middle section. This results in an easier building process of the wheels.


We use standard bearings. This means you can also buy bearings in Australia if you need to. Ours are just a little special, with two main differences: Our bearings have a higher fat filling grade. 30% is standard, whilst ours are filled to 50%. This not only prolongs their life, but also provides a better seal. Standard bearings have variations in play from their production. Tune bearings have the play specially determined dependent on their use. One single Tune bearing is not standard – the bearing in the free-wheel body on the left. It is constructed specifically to withstand high forces and last extra long.


Specs Endurorider

Hubs King / Kong
Rim Tune Endurorider
Hole 32 / 32
Nipple Sapim, Alu, anodised
Spokers SAPIM D-Light
max. rider weight 120 kg
Marathon 60
XC 45
AllMountain 80
Enduro 100
Downhill 45

Unser Enduro Laufradsatz! Aufgebaut mit unserer hauseigenen Tune Endurorider Felge unseren klassikern King und Kong

Rims Endurorider

Hight 20.5 mm
Outer width 34.0 mm
Inner width 29.8 mm
ERD 553 mm (650B), 591 mm (29")
Max. tire pressure 45 psi / 3,0 bar
Tire width 2.2" - 2.8"
Weight (±5%) 525 g (650B), 560 g (29")
tune Wheels

The tuning of running wheels has the most noticeable effect when it comes to weight savings. All the wheels are hand-fed, pressed and perfectly centered. Our bikes stand for the highest quality and have proven themselves over millions of kilometers.